
Chapter 35 Access Control
IES-708-22A User’s Guide
224
The following table describes the labels in this screen.
35.5 Service Access Control Screen
To open this screen, click Advanced Application > Access Control > Service Access
Control.
Figure 114 Advanced Application > Access Control > Service Access Control
The following table describes the labels in this screen.
Table 77 Advanced Application > Access Control > SNMP
LABEL DESCRIPTION
Up Click U to go back to the previous screen.
Get Community Enter the get community, which is the password for the incoming Get- and
GetNext- requests from the management station.
Set Community Enter the set community, which is the password for incoming Set- requests from
the management station.
Trap Community Enter the trap community, which is the password sent with each trap to the
SNMP manager.
Trap Destination
1~4
Enter the IP address of a station to send your SNMP traps to.
Port Enter the port number upon which the station listens for SNMP traps.
Trusted Host A “trusted host” is a computer that is allowed to use SNMP with the IES-708-
22A.
0.0.0.0 allows any computer to use SNMP to access the IES-708-22A.
Specify an IP address to allow only the computer with that IP address to use
SNMP to access the IES-708-22A.
Apply Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 78 Advanced Application > Access Control > Service Access Control
LABEL DESCRIPTION
Up Click Up to go back to the previous screen.
Services Services you may use to access the IES-708-22A are listed here.
Active Select the Active check boxes for the corresponding services that you want to
allow to access the IES-708-22A.
Comentarios a estos manuales