ZyXEL Communications IES-708 Guía de usuario descargar pdf (Pagina 359)

100

101

Chapter 54 Virtual Channel Management

IES-708-22A User’s Guide

359

This command adds a domain for 2684 routed mode traffic. The domain includes the

subscriber’s LAN IP addresses.

" You must use the rpvc gateway set and the rpvc set commands before you

use the rpvc route set command.

The following example adds a domain for a CPE device is connected to DSL port 1 on the

IES-708-22A and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI

35. The CPE device’s LAN IP address is 10.10.10.10 and uses a subnet mask of

255.255.255.0. This includes the CPE device’s LAN IP addresses and the IP addresses of the

LAN computers.

54.5.9 RPVC Route Show Command

Syntax:

ras> shdsl rpvc route show <portlist>

where

This command lists the domains for 2684 routed mode traffic.

<ip> =

The subscriber’s CPE LAN IP address in dotted decimal

notation.

/<netmask> =

The bit number of the subnet mask of the subscriber’s IP

address. To find the bit number, convert the subnet mask to

binary and add all of the 1’s together. Take “255.255.255.0” for

example. 255 converts to eight 1’s in binary. There are three

255’s, so add three eights together and you get the bit number

(24).

ras> shdsl rpvc route set 1 8 35 10.10.10.1/24

<portlist> =

The port(s) of the RPVC.

You can specify a single DSL port <1>, all DSL ports <*> or a

list of DSL ports <1,3,5>. You can also include a range of ports

<1,5,6~8>.

1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 447 448

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications IES-708 Guía de usuario Pagina 359

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications IES-708