ZyXEL Communications IES-708 Guía de usuario descargar pdf (Pagina 232)

Chapter 37 Alarm

IES-708-22A User’s Guide

232

The following table describes the labels in this screen.

37.4.1 Edit Alarm Event Setup Screen

Use this screen to specify the severity level of an alarm(s) and where the system is to send the

alarm(s).

To open this screen, click Alarm > Alarm Status. Then, click an alarm’s index number.

Figure 119 Alarm > Alarm Event Setup > Edit

Table 83 Alarm > Alarm Event Setup

LABEL DESCRIPTION

Alarm Status Click Alarm Status to go to a screen that displays the alarms that are currently

in the system (see Section 37.2 on page 229).

Alarm Port Setup Click Alarm Port Setup to go to a screen where you can configure the alarm

severity threshold for recording alarms on an individual port(s). See Section

37.5 on page 233.

Index This field displays the index number of the alarm in the list. Click this to specify

the severity level of an alarm(s) and where the system is to send the alarm(s).

See Section 37.4.1 on page 232.

Alarm This field displays the alarm category to which the alarm belongs.

eqpt represents equipment alarms.

dsl represents Digital Subscriber Line (DSL) alarms.

enet represents Ethernet alarms.

sys represents system alarms.

Condition Code This field displays the condition code number for the specific alarm message.

Condition This field displays a text description for the condition under which the alarm

applies.

Facility This field displays the log facility (local1~local7) on the syslog server where the

system is to log this alarm. This is for alarms that send alarms to a syslog

server.

SNMP This field displays “V” if the system is to send this alarm to an SNMP server. It

displays “-“ if the system does not send this alarm to an SNMP server.

Syslog This field displays “V” if the system is to send this alarm to a syslog server. It

displays “-“ if the system does not send this alarm to a syslog server.

Severity This field displays the alarm severity level (critical, major, minor or info).

Clearable This displays “V” if the alarm clear command removes the alarm from the

system. It displays “-“if the alarm clear command does not remove the alarm

from the system.

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 447 448

Sin comentarios

ZyXEL Communications IES-708 Guía de usuario Pagina 232