
ZyXEL Confidential
404XD3C0.docx
117/181
(2) Try (1) more times and sometimes cannot be resolved.
4. [BUG FIX] 050819842
Symptom: ZyWALL 5 will crash when upload firmware via GUI.
Condition
(1) Upload a very large file via GUI.
(2) Device will crash.
5. [BUG FIX] 050823954
Symptom: The IPSec rule swap without configuring ID Content will fail (XAUTH
case).
Condition:
(1) Add one static IPSec rule with XAuth (Rule one).
(2) Add one dynamic IPSec rule with XAuth. Keep the "Peer ID Content" and "Local ID
Content" unchanged "0.0.0.0" (Rule two).
(3) Dial the VPN tunnel from peer gateway, the device won't swap to rule two, and the
connection can not be built up.
6. [BUG FIX] 050822915
Symptom: VPN can not be established if reponder has multiple rules and the correct
rule's phase 2 ID type is subnet.
Condition:
Topology: ZyWALL_A(WAN)----(Internet)----(WAN) ZyWALL_B
(1) IPSec policy in ZyWALL_A:
Policy 1:
Local: 192.168.3.10/255.255.255.0
Remote: 192.168.2.7/255.255.255.0
Policy 2:
Local: 192.168.1.10/255.255.255.0
Remote: 192.168.2.6/255.255.255.0
(2) IPSec policy in ZyWALL_B:
Policy 1:
Local: 192.168.2.0/255.255.255.0
Remote: 192.168.1.0/255.255.255.0
(3) The other phase 1 and phase 2 parameters for ZyWALL_A and ZyWALL_B are the
same.
(4) Establish policy 1 tunnel from ZyWALL_B.
(5) ZyWALL_A should establish VPN tunnel by using policy 2, but it fails.
7. [ENHANCEMENT]
Add CI command "aux usrmdn [1/0]" to switch USR modem flag. If this flag is on, user
can dial USR modem successfully.
Note:
(1) For USR modem, user should disable hardware flow control(initial string is "at&f1");
or the modem speed should be 38400 BPS.
(2) This is a runtime CI command, and this flag is not saved into flash. User can add this
command into autoexec.net.
8. [BUG FIX] 050517977
Symptom: IPSec check rule conflict on IP 0.0.0.0 is incorrect.
Condition:
Comentarios a estos manuales