ZyXEL Communications ZYWALL 5 - V4.04 Guía de usuario Pagina 99

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 181
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 98
ZyXEL Confidential
404XD3C0.docx
99/181
Local ID: Type=DNS Content = a.a.a.a
Peer ID: Type=DNS Content = b.b.b.b
IPSEC: Local=Single 3.3.3.3, Remote=Single 4.4.4.4
2. Rule two:
IKE: Dynamic rule, enable XATUH and set as server mode.
Local ID: Type=DNS Content = d.c.b.a
Peer ID: Type=DNS Content = a.b.c.d
IPSEC Policy: Local=Single 1.1.1.1, Remote=Single 2.2.2.2
(3) Dial VPN tunnel from Bridge_A to Bridge_B, the VPN tunnel will fail to build up
by phase one ID mismatch.
16. [BUG FIX]
Symptom: User can’t receive mail through VPN tunnel when WAN is in PPTP
encapsulation.
Condition:
Topology:
PC1 (mail client) --- ZW5 (PPTP) === VPN tunnel === ZW70 ---- PC2 (mail server)
(1) Establish VPN tunnel between ZW5 and ZW70.
(2) ZW5's WAN is PPTP, enable AS.
(3) ZW70's WAN can be any encapsulation type, disable AS.
(4) PC1 receives mail from PC2 but it fails.
17. [BUG FIX]
Symptom: Asymmetrical route cannot work.
Condition:
Topology as follows:
PC (A) ---- [L]DUT(B)[W] ------- Internet --- HTTP server(D)(66.102.7.104)
| |
-- [L]Router(C)[W] --- Internet
(1) DUT configures a static route that forwarding packets of destination IP
66.102.7.104 through internal link to Router(C).
PC (A)’s default route entry is DUT (B).
Router (c) is NAT enabled.
(2) PC (A) establishes HTTP connection to HTTP server (D).
a. SYN Packet: A -> B (LAN) -> C (LAN) -> C (WAN) -> D.
b. SYN ACK Packet: D -> C (WAN) -> C (LAN) -> A.
c. ACK Packet: A -> B (LAN), and DUT drop it.
18. [BUG FIX]
Symptom: Trigger port can’t be reconnected.
Condition:
Topology:
PC1(192.168.1.33)------(LAN)ZyWALL(WAN:192.168.70.175)-----PC2(192.168.7
0.176)
(1) Reset to default romfile.
(2) Go to eWC>WAN>WAN1, set WAN IP Address=192.168.70.175.
(3) Go to eWC>NAT>Port Triggering>WAN1 Interface>Index 1, set Name=ftp,
Incoming Start Port=21, incoming End Port=110, Trigger Start Port=21,Trigger End
Port=21.
Vista de pagina 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 180 181

Comentarios a estos manuales

Sin comentarios