ZyXEL Communications PLA-470 V2 - V3.0.5 Guía de instalación Pagina 217

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 349
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 216
debian:home/carcelle/Projects/CPL/dLAN-linux-package-2.0#./con
-
figure
We can start by configuring the compilation parameters as illustrated in Figure
9.28.
The compilation of the PLC configuration tool can be started using the make
command as illustrated in Figure 9.29.
Once the compilation has been completed, the compiled files must be installed in
the correct disk locations using the make install command.
The configuration tool can then be run with the Ethernet/USB virtual board or
with the Ethernet board connected to a USB PLC or Ethernet device using the fol-
lowing command (see Figure 9.30):
carcelle@debian:~/Projects/CPL/dLAN-linux-package-2.0$sudo
dlanconfig eth0
The tool can be run on the eth0 or dlanusb0 interface. Figure 9.31 illustrates the
sensing of PLC devices connected to the PLC network performed by the configura-
tion tool.
In this example, the sensed PLC device corresponds to the HomePlug 1.0 specifi-
cation since its estimated physical data rate is around 12.829 Mbit/s.
A menu with the four following functionalities is proposed by the configuration
tool:
198 Configuration
Figure 9.28 Configuring the compilation parameters
Vista de pagina 216
1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 348 349

Comentarios a estos manuales

Sin comentarios