ZyXEL Communications IES-612-51A Guía de usuario descargar pdf (Pagina 105)

IES-612-51 User’s Guide

105

CHAPTER 12

ENET Port Setup

The ENET Port Setup screen allows you to configure settings for the Ethernet ports.

To open this screen, click Basic Setting, ENET Port Setup.

Figure 47 ENET Port Setup

The following table describes the labels in this screen.

Table 17 ENET Port Setup

LABEL DESCRIPTION

Port This is the port index number.

Active Select the check box to turn on the port. Clear it to disable the port.

Name Enter a descriptive name that identifies this port. You can use up to 31 ASCII

characters; spaces are allowed.

Speed Mode Select the type of Ethernet connection for this port. When you don’t use auto-

negotiation, you must make sure that the settings of the peer Ethernet port are

the same in order to connect.

Select Auto (auto-negotiation) to have the IES-612-51 automatically determine

the type of connection that the Ethernet port has. When the peer Ethernet

device has auto-negotiation turned on, the IES-612-51 negotiates with the peer

to determine the connection speed. If the peer Ethernet port does not have

auto-negotiation turned on, the IES-612-51 determines the connection speed by

detecting the signal on the cable and using full duplex.

Select 10 Copper if the Ethernet port has a 10 MB electrical connection.

Select 100 Copper if the Ethernet port has a 100 MB electrical connection.

Duplex The IES-612-51 uses full duplex Ethernet connections by default.

Apply Click Apply to save your changes to the IES-612-51’s volatile memory. The

IES-612-51 loses these changes if it is turned off or loses power, so use the

Config Save link on the navigation panel to save your changes to the non-

volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 413 414

Sin comentarios

ZyXEL Communications IES-612-51A Guía de usuario Pagina 105