
Chapter 55 Virtual Channel Commands
IES-612-51 User’s Guide
360
55.5.1 2684 Routed Mode Example
The following figure shows an example RFC 2684 (formerly RFC 1483) routed mode set up.
The gateway server uses IP address 192.168.10.102 and is in VLAN 1. The IES-612-51 uses
IP address 192.168.20.101. The subscriber’s device (the CPE) is connected to DSL port 1 on
the IES-612-51 and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and
VCI 35. The CPE device’s WAN IP address is 192.168.10.200. The routed domain is the LAN
IP addresses behind the CPE device. The CPE device’s LAN IP address is 10.10.10.10 and the
LAN computer’s IP address is 10.10.10.1. This includes the CPE device’s LAN IP addresses
and the IP addresses of the LAN computers.
Figure 185 2684 Routed Mode Example
Note the following.
• The CPE device’s WAN IP (192.168.10.200 in this example) must be in the same subnet
as the gateway’s IP address (192.168.10.102 in this example).
• The IES-612-51's management IP address can be any IP address, it doesn't have any
relationship to the WAN IP address or routed gateway IP address.
adsl rpvc arp agingtime
show
Displays how long the device stores the IP addresses of 2684 routed
mode gateways in the Address Resolution Protocol table.
M/L
adsl rpvc arp show Displays how long the device stores the IP addresses of 2684 routed
mode gateways in the Address Resolution Protocol table.
M/L
adsl rpvc arp flush Clears the IP addresses of 2684 routed mode gateways from the
Address Resolution Protocol table.
H/H
Table 146 RPVC Commands
COMMAND DESCRIPTION P
Comentarios a estos manuales