ZyXEL Communications IES-612-51A Guía de usuario Pagina 326

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 414
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 325
Chapter 54 ADSL Commands
IES-612-51 User’s Guide
326
54.2 ADSL Commands
Use these commands to configure the ADSL ports. See Chapter 13 on page 107 for
background information on ADSL.
up-max-rate The maximum ADSL upstream transmission rate (32~3000 Kbps).
up-min-margin The minimum acceptable ADSL upstream signal/noise margin (0~31db).
up-max-margin: The maximum acceptable ADSL upstream signal/noise
margin (0~31db).
up-min-rate The minimum ADSL upstream transmission rate (32~3000 Kbps).
up-target-
margin
The target ADSL upstream signal/noise margin (0~31db).
up-upshift-
margin
The upstream up shift noise margin (0~31 dB).
vlanlist You can specify a single VLAN <1>, all VLANs <*> or a list of VLANs <1,3,5>.
You can also include a range of VLANs <1,5,6~10>.
Table 132 ADSL Command Input Values
LABEL DESCRIPTION
Table 133 ADSL Commands
COMMAND DESCRIPTION P
adsl show <portlist> Shows the activation status, ADSL mode, maximum upstream
and downstream rate settings, profile and name of each ADSL
port.
L/L
adsl enable <portlist> Enables the specified ADSL port(s). M/H
adsl disable <portlist> Disables the specified ADSL port(s). M/H
adsl name <portlist><name> Sets the name of an ADSL port(s).
name: A descriptive name for the port. You can use up to 31
printable ASCII characters (including spaces and hyphens).
M/H
adsl reset <portlist> Resets the specified xDSL ports to their defaults. H/H
adsl tel <portlist><tel> Records the telephone number of an ADSL subscriber
telephone number.
tel: An ADSL subscriber’s telephone number. You can use up
to 15 ASCII characters (including spaces and hyphens).
M/H
adsl loopback
<portlist><f5><vpi><vci>
Performs an OAMF5 loopback test on the specified ADSL
port(s).
f5: Use f5 to perform an OAMF5 loopback test on the
specified DSL port. An Operational, Administration and
Maintenance Function 5 test is used to test the connection
between two DSL devices. First, the DSL devices establish a
virtual circuit. Then the local device sends an ATM F5 cell to be
returned by the remote DSL device (both DSL devices must
support ATM F5 in order to use this test).
vpi, vci: The Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI) identify a channel on this port.
Possible values for the VPI are 0~255.
Possible values for the VCI are 32~65535 if the VPI is 0. If the
VPI is not 0, possible values for the VCI are 1~65535.
H/H
Vista de pagina 325
1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 413 414

Comentarios a estos manuales

Sin comentarios