ZyXEL Communications IES-1248-51 Guía de usuario descargar pdf (Pagina 118)

100

101

Chapter 15 ENET Port Setup

IES-1248-51V User’s Guide

118

Speed Mode Select the type of Ethernet connection for this port. When you don’t

use auto-negotiation, you must make sure that the settings of the

peer Ethernet port are the same in order to connect.

Select Auto (auto-negotiation) to have the IES-1248-51V

automatically determine the type of connection that the Ethernet port

has. When the peer Ethernet device has auto-negotiation turned on,

the IES-1248-51V negotiates with the peer to determine the

connection speed. If the peer Ethernet port does not have auto-

negotiation turned on, the IES-1248-51V determines the connection

speed by detecting the signal on the cable and using full duplex.

When an Ethernet port is set to Auto, the IES-1248-51V tries to

make a fiber connection first and does not attempt to use the RJ-45

port if the fiber connection is successful.

Select 100 Copper if the Ethernet port has a 100 MB electrical

connection.

Select 1000 Copper if the Ethernet port has a 1000 MB (1 gigabit)

electrical connection.

Select 1000 Fiber if the Ethernet port has a 1000 MB (1 gigabit) fiber

optic connection.

Duplex The IES-1248-51V uses full duplex Ethernet connections.

Apply Click Apply to save your changes to the IES-1248-51V’s volatile

memory. The IES-1248-51V loses these changes if it is turned off or

loses power, so use the Config Save link on the navigation panel to

save your changes to the non-volatile memory when you are done

configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Table 18 ENET Port Setup (continued)

LABEL DESCRIPTION

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 653 654

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications IES-1248-51 Guía de usuario Pagina 118

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications IES-1248-51