
Chapter 67 ACL Commands
IES-1248-51V User’s Guide
537
Table 203 ACL Commands
COMMAND DESCRIPTION P
switch acl profile set <name>
<rule> <action>
Configures an ACL rule to classify the upstream traffic and
perform action(s) on the classified traffic.
Here are the criteria you can configure for rules in ACL
profiles. The rules are listed in sequence from highest
priority to lowest priority. The criteria within a rule are
position-independent.
etype <etype> vlan <vlan-id>
etype <etype> smac <mac-address>
etype <etype> dmac <mac-address>
vlan <vlan-id> smac <mac-address>
vlan <vlan-id> dmac <mac-address>
smac <mac-address> dmac <mac-address>
vlan <vlan-id> priority <priority>
etype <etype>
vlan <vlan-id>
smac <mac-address>
dmac <mac-address>
priority <priority>
protocol <protocol>
srcip <ip-address>/<mask-bits> [dstip <ip-
address>/<mask-bits> [tos <tos> [srcport <sport>
<eport> [dstport <sport> <eport>]]]]
where
etype <etype> = Ethernet type (0~65535
).
vlan <vlan-id> = VLAN ID (1~4094).
smac <mac-address> = Source MAC address.
dmac <mac-address> = Destination MAC address.
priority <priority> = Priority (0 ~ 7)
protocol <protocol> = Protocol type: tcp, udp, ospf,
igmp, ip, gre, icmp or user specified IP protocol number
<0 ~ 255>.
srcip <ip-address>/<mask-bits> = Source IP address
and subnet mask (0~32).
dstip <ip-address>/<mask-bits> = Destination IP
address and subnet mask (0~32).
tos <stos> <etos> = Sets the ToS (Type of Service)
range between 0 and 255.
srcport <sport> <eport> = Source port range
(0~65535).
dstport <sport> <eport> = Destination port range
(0~65535).
The following guidelines apply to classifiers.
M/H
Comentarios a estos manuales