
Chapter 45 VoIP
IES-1248-51V User’s Guide
326
45.2.2 Port Edit Screen
Use this screen to configure the VoIP settings of each of the IES-1248-51V’s ports.
Click VoIP > VoIP Port Setup > Port Edit. The following screen displays.
Figure 151 VoIP > VoIP Port Setup > Port Edit
The following table describes the labels in this screen.
Table 113 VoIP > VoIP Port Setup > Port Edit
LABEL DESCRIPTION
Port Select the port you want to configure.
Active Select this to enable VoIP on the selected port.
Customer Name If you configured a name in the Basic Setting > xDSL Port Setup
> xDSL Port Setting screen’s Customer Info field, it displays
here.
Termination Name Enter up to 31 alphanumeric characters for the name of this port’s
H.248 Termination. Spaces are not allowed. By default, the port’s
Termination name is “termX”, where X is the port number.
MG Name This field displays the H.248 media gateway name which you can
configure in the VoIP > Media Gateway screen.
DSP Profile Select the Digital Signal Processing (DSP) profile the port uses for
voice calls. If you have not configured any profiles, only the default
profile DEFVAL can be selected. Configure DSP profiles in the VoIP
> DSP Profile screen.
Data Profile Select the Digital Signal Processing (DSP) profile the port uses for
fax or modem calls. If you leave this field blank, the IES-1248-51V
uses the DSP profile you set in the previous field for the calls.
Configure DSP profiles in the VoIP > DSP Profile screen.
Comentarios a estos manuales