ZyXEL Communications IES-1248-51 Guía de usuario descargar pdf (Pagina 239)

100

101

Chapter 31 PPPoA to PPPoE

IES-1248-51V User’s Guide

239

PVID Type a PVID (Port VLAN ID) to assign to untagged frames received on

this channel.

Note: Make sure the VID is not already used for multicast VLAN

or TLS PVC.

Priority Use the drop-down list box to select the priority value (0 to 7) to add

to incoming frames without a (IEEE 802.1p) priority tag.

AC Name This field is optional. Specify the hostname of a remote access

concentrator if there are two access concentrators (or BRAS) on the

network or if you want to allow PAE translation to the specified access

concentrator. In this case, the IES-1248-51V checks the AC name field

in the BRAS's reply PDU. If there is a mismatch, the IES-1248-51V

drops this PDU. (This is not recorded as an PPPoE AC System Error

in the PPPoA to PPPoE Status screen, however.)

Service Name This field is optional. Specify the name of the service that uses this

PVC. This must be a service name that you configure on the remote

access concentrator.

Hellotime Specify the timeout, in seconds, for the PPPoE session. Enter 0 if there

is no timeout.

Apply Click this to add or save channel settings on the selected port.

This saves your changes to the IES-1248-51V’s volatile memory. The

IES-1248-51V loses these changes if it is turned off or loses power, so

use the Config Save link on the navigation panel to save your

changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to start configuring the screen again.

Show Port Select which ADSL port(s) for which to display PPPoA to PPPoE

conversion settings.

Index This field displays the number of the PVC. Click a PVC’s index number

to open the screen where you can look at the current status of this

PPPoA-to-PPPoE conversion. (See Section 31.3 on page 241.)

Note: At the time of writing, you cannot edit the VPI and VCI. If

you want to change them, add a new PVC with the desired

settings. Then, delete any unwanted PVCs.

Port This field displays the number of the ADSL port on which the PVC is

configured.

VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit

Identifier (VCI). The VPI and VCI identify a channel on this port.

PVID This is the PVID (Port VLAN ID) assigned to untagged frames or

priority frames (0 VID) received on this channel.

Priority This is the priority value (0 to 7) added to incoming frames without a

(IEEE 802.1p) priority tag.

Hellotime This field displays the timeout for the PPPoE session, in seconds.

DS / US VC Profile This shows which VC profile this channel uses for downstream traffic

shaping. The VC profile for upstream policing also displays if the

channel is configured to use one.

Table 69 PPPoA to PPPoE (continued)

LABEL DESCRIPTION

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 653 654

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications IES-1248-51 Guía de usuario Pagina 239

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications IES-1248-51