ZyXEL Communications IES-1248-51 Guía de usuario Pagina 75

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 654
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 74
Chapter 7 Introducing the Web Configurator
IES-1248-51V User’s Guide
75
DSCP Use this screen to set up DSCP on each port and to convert DSCP
values to IEEE 802.1p values.
TLS PVC Use this screen to set up Transparent LAN Service (VLAN stacking,
Q-in-Q) on each port.
ACL Use this screen to set up Access Control Logic profiles and to assign
them to each PVC.
Downstream
Broadcast
Use this screen to block downstream broadcast packets from being
sent to specified VLANs on specified ports.
SysLog Use this screen to configure the syslog settings.
Access Control Use this screen to configure service access control and configure
SNMP and remote management.
IP Bridge Use these screens to configure IP-aware bridging, where the IES-
1248-51V forwards packets based on destination IP address instead
of destination MAC address.
PPPoE
Intermediate
Agent
Use this screen to insert line information into client PPPoE Discover
Initialization (PODI) packets
Maximum MTU
Size
Use this screen to configure the Maximum Transmission Unit (MTU)
for the Ethernet interfaces. The Ethernet interfaces discard any
packets larger than this.
PVC Upstream
Limit
Use this screen to limit the transmission rate for upstream traffic by
PVC.
OUI Filter Use this screen to specify specific MAC address octets to filter.
Routing Protocol
Static Routing Use this screen to configure static routes. A static route defines
how the IES-1248-51V should forward traffic by configuring the
TCP/IP parameters manually.
Alarm
Alarm Status Use these screens to view the alarms that are currently in the
system.
Alarm Event
Setup
Use these screens to view and set the severity levels of the alarms
and where the system is to send them.
Alarm Port Setup Use this screen to set the alarm severity threshold for recording
alarms on an individual port(s).
VoIP
VoIP Port Setup Use these screens to configure the Voice over IP (VoIP) settings of
each of the IES-1248-51V’s subscriber ports.
H.248 Profile Use this screen to configure VoIP H.248 profiles.
DSP Profile Use this screen to configure information about the Digital Signal
Processing (DSP) profiles used by the IES-1248-51V.
Media Gateway Use this screen to configure the system’s H.248 interface.
VoIP Line Status
and Info
Use this screen to see detailed information about the VoIP
configuration currently active on each of the IES-1248-51V’s analog
phone ports.
Table 6 Web Configurator Screens (continued)
LABEL DESCRIPTION
Vista de pagina 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 653 654

Comentarios a estos manuales

Sin comentarios