
Chapter 62 IP Bridge Commands
IES-1248-51V User’s Guide
458
62.4.2 IP Bridge Route Show Command Example
Here is an example of manually created routing table entries.
The output values correspond to the input values of other IP bridge routing table
commands.
62.4.3 IP Bridge Route Runtime Command Example
This example displays the (run-time) routing table(s) for the “example2” domain.
The type field indicates whether this entry is used for upstream traffic (U, or
uplink interface) or downstream traffic (D, or downlink interface). By default, all
entries are for downstream traffic, unless the Edge Router IP is configured in the
edge router commands (see Section 62.3 on page 455).
The other output values correspond to the input values of other IP bridge routing
table commands.
ras> adsl ipbpvc route show example1
domain name ip/netmask gateway ip metric pri
-------------------- ------------------- --------------- ------ ---
example1 0.0.0.0/0 192.168.1.250 1 0
example1 4.4.4.0/24 5.6.7.8 2 1
example1 7.7.7.0/24 192.168.1.253 1 0
example1 192.168.37.0/24 192.168.1.251 1 0
ras> adsl ipbpvc route runtime example2
domain name ip/netmask gateway ip metric pri type
-------------------- ------------------- --------------- ------ --- -----
example2 192.168.1.253/32 - - - U
example2 192.168.1.35/32 - - - D
example2 2.2.2.0/24 - - - D
example2 192.168.37.0/24 192.168.1.250 1 0 D
example2 192.168.2.0/24 192.168.1.249 1 0 D
example2 0.0.0.0/0 192.168.1.252 1 0 D
Comentarios a estos manuales