
Chapter 30 2684 Routed Mode
IES-1248-51V User’s Guide
235
The following table describes the labels in this screen.
30.5 2684 Routed Gateway Screen
Use this screen to configure gateway settings.
To open this screen, click Advanced Application > 2684 Routed Mode >
Routed Gateway.
Figure 110 2684 Routed Gateway
Table 67 RPVC Arp Proxy
LABEL DESCRIPTION
Aging Time Enter a number of seconds (10~10000) to set how long the device
keeps the Address Resolution Protocol table’s entries of IP addresses
of CPE devices using 2684 routed mode. Enter 0 to disable the aging
time.
Apply Setting Click Apply Setting to save your changes to the IES-1248-51V’s
volatile memory.
The IES-1248-51V loses these changes if it is turned off or loses
power, so use the Config Save link on the navigation panel to save
your changes to the non-volatile memory when you are done
configuring.
Index This field displays the number of the IP address entry.
Gateway IP This field displays the IP address of the gateway to which the device
sends the traffic that it receives from this entry’s IP address.
VID This field displays the VLAN Identifier that the device adds to Ethernet
frames that it sends to this gateway.
MAC This field displays the subscriber’s MAC (Media Access Control)
address.
Flush Click Flush to remove all of the entries from the ARP table.
Comentarios a estos manuales