
Chapter 38 IP Bridge
IES-1248-51V User’s Guide
286
To open this screen, click Advanced Application > IP Bridge > Downlink
Interface.
Figure 134 IPB Downlink Interface
The following table describes the labels in this screen.
Table 90 IPB Downlink Interface
LABEL DESCRIPTION
Use the top section to create downlink interfaces manually.
Interface IP
NetMask
Enter the IP address and the number of bits in the subnet mask that
define the range of IP addresses to which this downlink interface
applies. If the destination IP address of a packet is in this range, the
IES-1248-51V tries to forward the frame to a subscriber in the
specified VLAN or PVC. Downlink interfaces in the same domain
cannot have overlapping IP addresses.
VID Enter the VLAN ID the subscriber is in. The IES-1248-51V uses this
VLAN ID when it forwards frames to the subscriber. It also uses the
VLAN ID to identify the domain the downlink interface is in. You have
to add the VLAN ID to an IP bridge domain before you can enter it
here.
Comentarios a estos manuales