ZyXEL Communications IES-1248-51 Guía de usuario Pagina 142

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 654
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 141
Chapter 17 xDSL Profiles Setup
IES-1248-51V User’s Guide
142
17.2 ATM QoS
ATM Quality of Service (QoS) mechanisms provide the best service on a per-flow
guarantee. ATM network infrastructure was designed to provide QoS. It uses fixed
cell sizes and built-in traffic management (see Section 17.3 on page 142). This
allows you to fine-tune the levels of services on the priority of the traffic flow.
17.3 Traffic Shaping
Traffic shaping is an agreement between the carrier and the subscriber to regulate
the average rate and fluctuations of data transmission over an ATM network. This
agreement helps eliminate congestion, which is important for transmission of real
time data such as audio and video connections.
Note: Traffic shaping controls outgoing (downstream) traffic, not incoming (upstream).
17.3.1 ATM Traffic Classes
These are the basic ATM traffic classes defined by the ATM Forum Traffic
Management 4.0 Specification.
17.3.1.1 Constant Bit Rate (CBR)
Constant Bit Rate (CBR) is an ATM traffic class that provides fixed bandwidth. CBR
traffic is generally time-sensitive (doesn’t tolerate delay). CBR is used for
connections that continuously require a specific amount of bandwidth. Examples
of connections that need CBR would be high-resolution video and voice.
Down Shift SNR The downstream down shift signal to noise margin (0-31 dB). When
the channel’s signal to noise margin goes below this number, the
device shifts to a lower transfer rate. Configure the downstream down
shift signal to noise margin to be less than or equal to the target
downstream signal to noise margin and greater than or equal to the
minimum downstream signal to noise margin.
Add Click Add to save your changes to the IES-1248-51V’s volatile
memory. The IES-1248-51V loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to start configuring the screen again.
Table 26 Port Profile (continued)
LABEL DESCRIPTION
Vista de pagina 141
1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 653 654

Comentarios a estos manuales

Sin comentarios